Filling The Water Tank - Rowenta IS6300 Manual Del Usuario

Hanger with Roll & Press system assembly
1. Unscrew the hanger fastening screw at the bottom of the hanger (fig. 7).
2. Hold the hanger such that the Roll & Press system handle is on the same side as the locking
hook.
3. Insert the hanger vertically on the top of the pole. The holes at the bottom of the hanger and
in the pole should be at the same level (fig. 8).
4. Put the screw back and screw in as far as it will go so that the hanger is firmly fixed to the
pole (fig. 9).
5. Install the steam head between the hanger hooks.
2 • Filling the water tank
IMPORTANT: Your product is designed to operate using untreated tap water. If your water is
very hard (check with your local water authority) it is possible to mix untreated tap water with
store-bought distilled water in the following proportions 50% untreated tap water with 50%
distilled water. Heat concentrates the elements contained in water during evaporation. The
types of water listed below may contain organic waste, mineral or chemical elements that can
cause spitting, brown staining or premature wear of the appliance: water from clothes dryers,
scented or softened water, water from refrigerators, batteries, air conditioners, rain water,
boiled, filtered or bottled water. These types of water should not be used. Only use store
bought distilled water as advised above.
• Ensure that the steamer is unplugged. Remove the water tank from the base of the appliance
by pulling the handle upwards (fig. 10). Unscrew the tank cap and fill the tank (fig. 11).
Maximum capacity is indicated by the "max" mark.
• After closing the cap, turn the tank down and hold it by the handle. Check that no water is
leaking through the cap.
• Place the water tank on the base (fig. 12).
USE
WARNING: Never steam a garment while it is being worn.
The flexible pipe and the end of the steam head can become extremely hot during
use. This is perfectly normal. Be careful and avoid any prolonged contact.
1 • Setting up
• Only operate the steamer on the floor clear of any materials which may obstruct the base
of the steamer, ensure the floor is dry, flat, stable and heat-resistant. Do not obstruct the
openings on the lower part of the appliance. This device should not be used on very thick
carpets or rugs.
• Undo the Velcro strip and completely unwind the electrical cord.
• Plug in to power socket (fig.13).
• Switch on by pressing the pedal located at the front of the device. The power indicator light
will come on (fig.14).
• The device will begin producing steam after approximately 60 seconds.
18