RIDGID R4040 Manual Del Operador página 16

ASSEMBLY
INSTALLING WATER TRAY EXTENSI ON
See Figure 15.
 Standing at the back of the saw, hold the water tray
extension with the tray tabs toward the slots.
 Tilt the tray and slip the tray tabs between the frame top
and frame bottom. Tray should be over pump power
cord and water hose.
 Once the extension slides into place, lower until the tray
tabs fit into the holes under frame.
INSTALLING THE MITER GUIDE
See Figure 16.
The miter guide can be used from both the left and right side
of the cutting wheel.
 Place the slot on the underside of the miter guide on the
sliding table fence.
 Lock the miter guide securely to the table by turning the
miter guide knob clockwise.
To adjust angles:
 Loosen the miter guide knob.
 Set to the desired angle by moving the guide left or right.
 Tighten the knob securely.
FILLING/CHANGING THE WATER RESERVOIR
See Figure 17.
 Install drain cap.
 Fill the water reservoir with clean tap water to the fill line.
Do not fill past the "maximum" line on the tray.
To change reservoir water:
 Unplug the saw.
 Remove the drain cap and empty waste water into a
bucket. Do not allow the water to splash onto the ground
or around the machine.
 Rinse the water reservoir thoroughly.
 Discard the waste water in accordance with local
regulations.
 Replace the drain cap and refill tray with clean water.
NOTE: Drain fits standard size garden hose.
TRAY TAB
WATER TRAY
EXTENSION
MITER
GUIDE
DRAIN CAP
16 — English
WATER
FRAME
TRAY
TO LOOSEN
TO TIGHTEN
SLIDING
TABLE
FENCE
TRAY TAB
Fig. 15
MITER GUIDE
KNOB
Fig. 16
WATER
RESERVOIR
MAXIMUM
FILL LINE
MINIMUM
FILL LINE
Fig. 17