Cequent Towing Products 24748 Instrucciones De Instalación

Fascia
Trunk pan
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 24748F
Wrenches: 3/4", 7/8"
Drill Bits: 1/2"
Seal holes drilled
in trunk pan to
prevent intrusion
of exhaust fumes
and water.
1 1 1 1
Qty. (1) Bolt 1/2-13 X 1.75
2 2 2 2 Qty. (2) Flat Washer
3 3 3 3 Qty. (1) Spacer
4 4 4 4 Qty. (5) Lock Washer
1. Note: Remove spare tire before drilling!
2. Raise hitch into position and install the 1/2-13 hex bolt at tow hook location. Using the hitch as a template drill the three (3) 1/2"
holes used for the attachment of the hitch as Shown above. Install three (3) 1/2-13 carriage bolts.
3. After placing the long spacer (2 sq. Holes) in the approximate position shown inside the trunk pan use it as a template to drill the
remaining 1/2" hole. Install remaining fasteners.
4. Tighten all fasteners to the required torque specification.
5. Seal holes drilled in trunk pan to prevent intrusion of exhaust fumes and water.
6. Reinstall spare tire in trunk.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z 2005, 2006, 2008, 2015 Cequent Towing Products – Printed in Mexico
Installation Instructions
VW Jetta Sedan
VW City Jetta (Canada Only)
Except Turbo and all Wagons
(Sold separately)
Drawbar Kit:
3593
Drawbar must be used in the
RISE position only.
Long block
6
6
8
8
2
4
5
4
Frame rail
5
Tighten all 1/2" GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Do Not Exceed Lower of Towing Vehicle
2000 LB (908Kg) Max Gross Trailer Weight
200 LB (90.8 Kg) Max Tongue Weight
Wiring Access Location: PC3, PC4
Remove spare tire before drilling!
1-1/4"
Drilled holes
4
5
5 5 5 5
Qty. (5) Nut 1/2-13
6 6 6 6 Qty. (4) Carriage Bolt 1/2-13 X 1.75
7 7 7 7 Qty. (2) Spacer (sq. Holes)
8 8 8 8 Qty. (1) Bar (Long Block)
Sheet 1 of 3 24748N
Part Numbers:
Manufacturer's Rating or
6
7
5
4
3
Existing hole
2
1
10-19-15
Form F206 Rev A 5605
24748
77106
24783
Tow hook
Rev. D