Publicidad
Idiomas disponibles
Idiomas disponibles
License plate holder relocation
and/or modification required to
install hitch, see 49802 or 5443
sold separately.
Existing tow hook bolt.
(Both sides)
Fascia trim required. Obtain
vehicle owners approval before
cutting
NOTE: If front mounted license plate is present, license plate holder relocation and/or modification required to install hitch,
see 49802 or 5443 sold separately.
Note: Obtain vehicle owners approval before cutting. Trim fascia for receiver tube.
1.
Measure from the tow hook bolt center to the ground.
2.
Subtract 3/4"(.750)[19.05 mm] from step 1.
3.
Measure the difference to the front of the fascia and mark.
4.
Mark 3-1/4" up from the lower mark.
5.
Locate the center of the fascia from left to right and mark 1-5/8" each side. ( 3-1/4" square)
6.
Drill (4) 3/8" hole in corners.
7.
Carefully cut the 3-1/4" hole from the fascia.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2007 Cequent Towing Products
Installation Instructions
Chevrolet Silverado 2500 HD, 3500 HD
GMC Sierra 2500 HD, 3500 HD
Note: Fascia trim required.
Obtain vehicle owners approval before cutting
Sheet 2 of 6
3-1/4" (3.25) [82.55mm]
3-1/4" (3.25) [82.55 mm]
1-5/8"(1.625) [41.275 mm]
3-1/4" (3.25) [82.55 mm]
3-1/4" (3.25) [82.55 mm]
Bumper support
Tow hook
Measure from tow hook bolt.
65050N
8-17-07
Part Numbers:
65050
Rev. A
Publicidad
