Arregui Perfect Manual De Instrucciones página 8

4. ERROR DIAGNOSIS WHEN CHANGING
THE MASTER CODE
• Press "ON".
• Press "ENTER".
• Press "4".
• Press "ENTER".
• Enter the service code "160400" and press "ENTER".
Once the lock has opened using the current master code, after
pressing "ENTER" it beeps 5 times and the green light flashes
5 times.
V ANCHOR (ANCHOR BOLT)
Drill a hole in accordance with the table.
Clean the hole with a brush.
Use a hammer to install the anchor.
Screw the anchor into the wall until it is steady.
T
T
5. MAINTENANCE
Periodically (every 6 months) check the condition of the battery
compartment to detect possible signs of rust, sulphation, etc.
Grease/oil any mechanical moving parts, such as locks and
bolts.
6. KEY COPY
In the case of a safe with a key, if you lose the key you may
request a copy by indicating the serial number of your safe,
which is located on the bottom right of the door.
The V anchor (anchor bolt) is designed to install medium-to-heavy items
using a through hole. V anchors can be used with concrete, natural
stone and dense bricks (with no holes). When adjusting the V anchor
(anchor bolt), remember that the distance between the installation
points and the end of the base have a significant impact on the load. If
these distances are reduced, the load is also reduced.
Installation of the anchor
arameters for installing V anchors
Dimensions Length
of the anchor of the
(in mm) anchor
(L)
80/120 120
10/150 150
10/200 200
12/140 140
12/180 180
16/180 180
D – Diameter of the drill bit
L – Thickness of the material installed
M – Minimum depth of the perforation
H – Minimum depth of the anchor installation
Diameter Minimum
of the depth of the
drill bit perforation
(D) (M)
8 90
10 120
10 170
12 110
12 150
16 150
En
Minimum
depth of the
installation
(M)
50
60
60
80
80
100