RedMax BTR250PL Manual De Taller página 12

5. Disconnect wires (A, gray), (B, black) and (C, red) to
the motor, disconnect connector (D) for the keypad,
main switch and to the fan.
D
A
5.12.2 To assemble the control unit
1. Connect the cables from the motor to the control unit
with (A, grey) at the top, followed by (B, black) in the
middle and (C, red) at the bottom. Connect
connector (D) to the control unit for the keypad, fan
and main switch. Make sure the connector is
plugged firmly into the control unit.
D
A
2. Place all the control unit components in the battery
housing. Take care to return all the cables to their
correct positions to avoid pinching.
12 - Repair instructions
B
C
B
C
3. Fasten the 2 screws to the control unit (G) and the 2
screws to the battery contact (H).
4. Assemble the battery housing. See
battery housing on page 14
5. Assemble the wear guard under the battery housing.
To assemble the control unit on page 12
See
6. Assemble the handle and the operating handle. See
To assemble the operating handle on page 14
G
H
H
G
To assemble the
572 - 001 - 28.03.2018