Charger Operation; Charging The Battery - SNOWJOE 24V-SS10-CVR Manual Del Operador

NOTE: If the charge level button does not appear to be
working, insert it into the charger and charge as needed.
NOTE: Immediately after using the battery pack, the charge
level button may display a lower charge than it will if checked
a few minutes later. The battery cells "recover" some of their
charge after resting.

Charger Operation

m
WARNING!
Charge only iON+ 24V lithium-ion battery
packs with its compatible iON+ 24V lithium-ion quick charger.
Other types of batteries may cause personal injury and
damage.
To reduce the risk of electric shock, do not allow water to flow
into the charger's AC/DC plug.
When to Charge the iON+ 24VBAT
Lithium-Ion Battery
NOTE: The iON+ 24VBAT lithium-ion battery packs do
not develop a "memory" when charged after only a partial
discharge. Therefore, it is not necessary to run down the
battery pack before placing it into the charger.
• Use the battery charge indicator lights to determine when to
charge your iON+ 24VBAT lithium-ion battery pack.
• You can "top-off" your battery pack's charge before starting
a big job or after a long day of use.

Charging the Battery

1. Press the push lock buttons on the battery to pull the
battery pack out of the equipment (Fig. 3).
Fig. 3
Push lock button
2. Check that the mains voltage is the same as that marked
on the rating plate of the battery charger. Then, insert the
charger's plug into the electrical wall outlet. When you
plug in the charger, the top right green light will illuminate
and stay green (Fig. 4).
Fig. 4
Power on
green
3. Place the battery pack into the charger by sliding the pack
to lock it into position. When you insert the battery into
the charger, the top right green light will go off, and the
top left red light will illuminate to indicate that the battery
is charging (Fig. 5).
Fig. 5
Battery pack
Charging
red
Charger
Fully
Charged
green
4. When the charger light turns green, the battery is fully
charged (Fig. 5).
NOTE: A fully discharged pack with an internal
temperature in the normal range will fully charge in
1 hr 50 mins (between 32ºF/0ºC and 113ºF/45ºC).
5. If the light indicators do not come on at all, check that
the battery pack is fully seated into the bay. Remove
the battery pack and reinsert. If the problem persists,
contact an authorized Snow Joe
call the Snow Joe + Sun Joe
®
1-866-SNOWJOE (1-866-766-9563) for assistance.
6. When charging is complete, remove the battery from the
charger by pressing the push lock buttons and sliding the
battery backward to unlock it from the charger (Fig. 6).
9
Charger
+ Sun Joe dealer or
® ®
customer service center at
®