Intended Use - Mestra 080614 Manual De Instrucciones

Model saw
NOTE: Carefully read this manual. It contains important safety information in the installation, use and maintenance. If
the equipment is used in a manner not specified by the manufacturer, the security provided by the equipment
may be compromised.
Meaning of the symbols on the unit
Danger. Risk of injury.
Read completely these instructions before op-
erating the unit.
Electric shock risk.
Use safety goggles.
Wear safety gloves.
Wear a mask.
Precautions
▪ Keep this manual in a suitable place to consult it in
the future.
▪ Check the overall state of the unit just upon unpack-
ing it.
▪ The damage caused by a faulty installation or usage
of the unit will not be covered by the warranty.
▪ the risk of electric shock, this equipment must only
be connected to a properly grounded power source.
Before connecting the appliance, check that the iden-
tification label indicates the correct voltage. The in-
stallation must comply with all applicable safety
standards.
▪ Remove any dirt or water remains from the cord con-
nection.
▪ Do not pull, twist or fold the power cord excessively.
▪ Do not touch the unit or the power cord with wet
hands.
▪ Place the unit in a dry place, away from dust, water
splashes and flammable materials (alcohol, solvents,
etc.).
▪ Unplug the unit immediately whenever you notice an
unusual noise, smell or smoke.
▪ Do not allow children or non-qualified personnel
handling the unit.
▪ Do not use the unit if any doubts. Contact the suppli-
er for questions or detailed information about prob-
lems with the unit.
▪ Do not dismount, repair or modify the unit.
▪ Unplug the unit in case of storm and when you are
not going to use it for a long time.
▪ Unplug the unit before cleaning, do not use chemical
products.
▪ Contact the supplier for questions or detailed infor-
mation about problems with the unit.
▪ Before connecting the device, make sure it is placed
on a firm and solid surface.
▪ The cord may only be replaced by one with the same
characteristics as supplied by the manufacturer.
▪ During operation of the unit, use sufficient protection
(gauntlets, safety goggles and a face-mask).
▪ Wear proper working cloth. Loose cloth, hanging or
long hair could be caught by the machine.
▪ Always use a suction system.
▪ Do not bridge the safe switches.
▪ If the motor shaft locks during normal operation, dis-
connect the unit from the mains before attempting to
release it by turning it manually.
▪ Never polish, brush or grind materials which may
give off particles which are toxic if inhaled.
▪ Disconnect the unit from power supply before chang-
ing the saw.
▪ When you replace the saw, make sure that the protec-
tor is clean and in good conditions.
▪ Dot saw materials different from plaster models, spe-
cially metal objects.

Intended use

The R-080614 is a simple model saw designed be easily
used in the field of dental mechanics.
Unit parts (page 2)
A Head
B Main switch
C Clamp
D Magnet button
E Head lock
F Saw button
G Saw
H Table
Installation
Environmental conditions:
▪
Use indoors only.
▪
Environmental temperature: 5-40 ºC [41-104 ºF]
▪
Max. relative humidity: 0-95 %
▪
Degrees of protection: IP20
1. Carefully unpack the model trimmer. Make sure the
unit has not suffered any damage during the
transport.

EN