Troubleshooting - Wentronic Goobay 54754 Instrucciones De Uso

EN User Manual
Voltage Converter AC/AC
1 Safety instructions
The user manual is part of the product and contains important information for correct use.
• Read the user manual completely and carefully before use.
The user manual must be available for uncertainties and passing the product.
• Keep this user manual.
Notes for network separation
The product has no power switch and may be used only in easily accessible outlets to
quickly remove it in an emergency and after use.
Voltage-free only with pulled plug.
• In case of emergency, during thunderstorms and after use, pull the product on its
plug housing! In case of emergency, during thunderstorms and after use, pull the
product on its plug housing!
• Do not open the housing.
• Do not modify product and accessories.
• Do not short-circuit connectors and circuits.
• Do not insert objects into air vents or sockets!
A defective device may not be put into operation, but must be disconnected from mains
and protected against further use.
• Use product, product parts and accessories only in perfect condition.
• Avoid stresses such as heat and cold, moisture and direct sunlight, microwaves,
vibrations and mechanical pressure.
• In case of questions, defects, mechanical damage, trouble and other problems,
non-recoverable by the documentation, contact your dealer or producer.
Not meant for children. The product is not a toy!
• Secure packaging, small parts and insulation against accidental use.
Heat storage
• Do not cover the product.
• Keep and vents free.
• Do not use in sealed environments.
Risk of injury by stumbling and falling
• Mind placing cables in a way, nobody will be disabled and the cable not be dama-
ged.
• Install the system and devices attached to it in a way that persons cannot be inju-
red, or objects not be damaged for example by dropping or stumbling.
2 Description and function
2.1 Product
This product is a voltage converter for use with USA electrical/electronic household appli-
ances in Europe. It converts 230 V
2.2 Scope of delivery
Voltage Converter AC/AC, User Manual
2.3 Operating Elements
1 Air vents
2 US/Japanese socket (type A,
NEMA 1-15, 2-pin)
3 Euro plug
2.4 Specifications
Article number 54754
US/Japanese socket (type A,
Connectors NEMA 1-15, 2-pin),
Euro plug (type C, CEE 7/16)
230 V , 50 Hz,
Input
cosΦ = 0.73 (no load)
Output voltage 110 V
31-45 W short-time load, up
to 1 h
Output power
0-30 W permanent load
Fuse
Protection class
Protection level
Dimensions 88 x 62 x 88 mm
Weight 509 g
Cable length -
REV2021-07-16
V2.0cl
Subject to change without notice.
to 110 V .
4 US/Japanese socket (type B,
NEMA 5-15, 3-pin)
5 Hybrid plug
54755
US/Japanese socket (type B,
NEMA 5-15, 3-pin),
Hybrid plug (Type E + F, CEE
7/7)
230 V , 50 Hz,
cosΦ = 0.2 (no load)
110 V
71-100 W short-time load, up
to 1 h
0-70 W permanent load
Thermal fuse 250 V , 2 A, 125°C
II
IP 20
115 x 84 x 68.7 mm
1280 g
1.8 m
3 Intended use
The product is not suitable for use with IT equipment.
We do not permit using the device in other ways like described in chapter "De-
scription and Function" or in the "Safety Instructions". Use the product only in
dry interior rooms. Not attending to these regulations and safety instructions
might cause fatal accidents, injuries, and damages to persons and property.
4 Preparation
1. Check the scope of delivery for completeness and integrity.
2. Compare the specifications of all used devices and ensure compatibility.
5 Connection and operation
NOTICE! Material damage
• Use the product only with electrical/electronic household appliances!
• Do NOT operate IT equipment with the appliance!
• Do NOT operate power strips with the appliance!
1. Insert the Euro plug or Safety power plug of the voltage converter into a free and
easily accessible socket.
2. Connect your terminal device to the US/Japan socket of the voltage converter.
Pay attention to the power limits for short-time and permanent loads as specified in
section 2.4!
3. Disconnect all plug connections after use.
6 Maintenance, Care, Storage and Transportation
The product is maintenance-free.
NOTICE! Material damage
• Only use a dry and soft cloth for cleaning.
• Do not use detergents or chemicals.
• Store the product out the reach of children and in a dry and dust-protected am-
bience when not in use.
• Store cool and dry.
• Keep and use the original packaging for transport.
7

Troubleshooting

Problem Solution
• Observe the assembly sequence in the section
The voltage converter does
not work.
• Make sure that the cables are connected properly.
Unpleasant odours, hum- • Disconnect the unit from the mains immediately!
ming, etc. The unit is overloaded.
Other problems • Contact the dealer or manufacturer.
8 Disposal instructions
8.1 Product
According to the European WEEE directive, electrical and electronic equipment
must not be disposed with consumers waste. Its components must be recycled or
disposed apart from each other. Otherwise contaminative and hazardous
substances can damage the health and pollute the environment.
As a consumer, you are committed by law to dispose electrical and electronic devices to
the producer, the dealer, or public collecting points at the end of the devices lifetime for
free. Particulars are regulated in national right. The symbol on the product, in the user
manual, or at the packaging alludes to these terms. With this kind of waste separation,
application, and waste disposal of used devices you achieve an important share to
environmental protection.
WEEE No: 82898622
8.2 Packaging
Packaging can be disposed of free of charge at the suitable collection points – pa-
per belongs in paper bins, plastics belong in yellow sacks and glass belongs in
used glass bins.
DE4535302615620
9 EU Declaration of conformity
With the CE sign Goobay®, a registered trademark of the Wentronic GmbH
ensures, that the product is conformed to the basic European standards and
directives.
10 Symbols used
Alternating current
Class II equipment
For indoor use only
Recycling
- 2 -
54754, 54755
"Connection and operation".
IEC 60417- 5032
IEC 60417- 5172
IEC 60417- 5957
ISO 7001 - PI PF 066
by Wentronic GmbH | Pillmanstraße 12
38112 Braunschweig | Germany
Goobay®