Installation Steps - LUND Ventvisor Elite Instrucciones De Instalación

Installation Steps

Roll down window. Buff the inside felt surface
with scotch brite pad. Then clean with alcohol
clean
1
NOTE: visors mount on the inside of the window
Slide the front end flange of the visor into position outside the window channel between the rubber trim and mirror
cap. Then rotate visor up and slide top and rear flanges inside the window channel.
3
NOTE: Proper placement is important to prevent window from breaking flange during operation.
Press the exposed area of tape against the surface and
verify position.
4
Apply pressure along the inside of window channel and
flange edges to secure in place.
6
NOTE: Actual application may vary slightly from illustrations.
pad.
inside of vehicle
channel.
slide flange between
rubber and mirror cap
Remove the tape from the front and rear flanges. Peel
back 2" (5cm) of tape liner from each end of top
free end
2
front end
flange
With the visor in its final position, remove the remain-
der of the tape liner by pulling on free ends.
5
Continue to apply pressure to ensure that the visor
remains properly seated inside the window channel
as window is slowly closed. Leave window up for 72
hours to secure visor to window channel.
72
50°F / 10°C Min.
7
Page 2 of 3
flange.
free end
rear end flange
front end flange