Publicidad
Step 21
If your unit teeters and one of the LEVELERS is not touching the fl oor, turn the LEVELER out of the LEG until it touches the
å
fl oor. Slide the DOOR over to the left side of your unit.
Diagram #1 : The gap between the DOOR and the side of your unit should be constant from top to bottom. If it is not, then
å
make adjustments below.
Diagram #2: If your door has a larger gap near the bottom, then turn the left front LEVELER out of the LEG a couple of
å
turns. You may need to turn the LEVELER a couple of turns again to get your DOOR adjusted as shown in diagram #1.
Diagram #3: If your door has a larger gap near the bottom, then turn the right front LEVELER out of the LEG a couple of
å
turns. You may need to turn the LEVELER a couple of turns again to get your DOOR adjusted as shown in diagram #1.
If further door adjustments are needed, loosen the SCREWS in the WHEEL SUPPORTS a 1/4 of a turn, make any needed
å
adjustments, and tighten the SCREWS as shown in the enlarge view.
The gap
between
the DOOR
and the unit
should be
constant from
top to bottom.
Page 26
Loosen these SCREWS
a 1/4 of a turn, make
adjustments, and tighten.
Diagram #1
To eliminate this large
gap, turn the front left
LEVELER out.
Diagram #2
421191
To eliminate this large
gap, turn the front
right LEVELER out.
Diagram #3
www.sauder.com/service
Publicidad
