Bissell SPOTBOT PET 33N8 Serie Guía De Uso página 8

Operations
6. To suction up the dirt and cleaning solution,
position the suction nozzle over the cleaned
area, apply downward pressure on the tool,
and pull nozzle toward you. You should see the
dirty solution pass through the nozzle. Continue
until no more solution can be removed.
NOTE: In manual mode, the SpotBot is
equipped with a safety feature which will
shut the unit off after 30 minutes. Press
Pause/Resume to resume cleaning.
7. If the stain is still visible, repeat steps 4-6 as
necessary.
8. When the cleaning is complete, lightly drag
the suction nozzle across the stain to further aid
in drying the cleaned area.
9. Before turning off the SpotBot, suction up
clean water to thoroughly rinse out the inside of
the vacuum flex hose. Then, lift the vacuum flex
hose upwards to drain any remaining water into
the dirty tank.
10. Press the STOP button to turn off the
machine.
11. Disconnect the cleaning tool from the vacuum
flex hose by pushing down on the button lock
and pulling straight off (do not twist tools to
remove them).
12. Unplug the machine and wrap the cord
around the cord wraps. Attach the Tough
Stain Brush to the base of machine. Wrap
the hose around the machine and secure into
the hose connector.
Storage
1. Press the STOP button to turn the unit off.
Unplug the power cord from the outlet. Wrap
power cord around the cord wrap.
2. Empty and rinse the dirty water/collection
tank after each use, or when dirty water reaches
the indicated maximum fill line. To remove the
tank, lift up the dirty tank latch and pull the tank
out. Dump out the dirty water and rinse. Replace
the tank into the unit for storage. After using the
SpotBot's automated feature, wipe the window
and brushing area with a soft cloth.
3. If you were using your SpotBot manually, wrap
the vacuum flex hose around the unit and secure
the hose into the hose connector on the front of
the unit.
4. Store unit indoors at room temperature
(40° to 110°F).
www.BISSELL.com
8
WARNING
To reduce the risk of electric shock, turn power switch
off and disconnect plug from electrical outlet before
performing maintenance or troubleshooting checks.
Tips
» If a significant amount of water and solution
remains in the clean tank, your unit can be
stored with liquid in the clean tank. However, if
you have added Oxy Boost into the clean tank,
it cannot be stored in the the unit and should
be flushed.
» Clean out the black valve periodically inside of
the dirty water/collection tank.
11.
2. 3.