Publicidad
Idiomas disponibles
Idiomas disponibles
Section 4: Operation
OPERATING
THE
G EN ERATO R
Starting
the En ine
Disconnect
all electrical
loads from
the generator.
Use the
following
start
instructions:
1.
Make
sure unit is on a level surface.
iMPORTANT:
Failure
1o start
and operate
unit on a level
surface
wiii
cause the unit
not to start
or shut down
during
operation.
2.
Turn
red fuel valve [o"On"
position
(Figure
4).
3.
Start
engine
according
1o instructions
given in engine
opera[or's
manual.
WARNING
1
When
starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
NEVER start or stop engine with electrical
devices plugged in
and turned
on.
NOTE:
If engine starts after 3 pulls but fails to run, or if
uni[ shu[s down during operation,
make sure uni[ is on a
level surface and check for proper oil level in crankcase.
This uni[ may be equipped with a low oil protection
device.
See engine operator's
manual.
WARNING
DO NOT touch hot surfaces and avoid hot exhaust gases.
Allow equipment
to cool before touching.
Keep at least 5 ft. (152 cm) clearance on all sides of generator
including overhead.
Code of Federal Regulation
(CFR) Title 36 Parks, Forests, and
Public Property
require equipment
powered by an internal
combustion
engine to have a spark attester, maintained
in
effective working
order, complying
to USDA Forest service
standard 5100- I C or later revision. In the State of California
a
spark arrester
is required under section 4442 of the California
Public resources code. Other
states may have similar laws.
Connecting
Electrical
Loads
• Let engine
stabilize
and warm
up for a few minu[es
after
starring.
• Plug in and turn
on the desired
120 and/or
240 VoI[AC,
single phase, 60 Hz electrical
loads.
• DO
NOT
connect
240Volt
loads to the
120Vol[
duplex
receptacles.
• DO
NOT
connect
3-phase
loads [o the generator.
• DO
NOT
connect
50 Hz loads [o the generator.
• DO
NOT
OVERLOADTHE
GENERATOR.
See
"Don't
Overload
Genera[or'.
CAUTION
See "Don't
Overload
Generator".
Start generator
and let engine stabilize before connecting
electrical
loads.
Connect
electrical
loads in OFF position, then turn ON for
operation.
Turn electrical
loads OFF and disconnect
from generator
before stopping generator.
O
Publicidad
