Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Vehicle
Frame
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75556F
Wrenches: 18mm
Drill Bits: None
Existing weldnuts in frame.
Typical both sides of vehicle.
Qty. (4)
12mm-1.75 X 35mm Cl 10.9 Hex head bolts
1
1.
It may be necessary to temporarily lower exhaust system to allow for easier access to install frame bolts. If necessary remove
(2) rearward rubber isolator hangers per side. Spraying with a lubricant will aid in removing isolators off of studs.
2.
Raise hitch into position and install 12mm bolts and conical washers supplied into existing weldnuts in vehicle frame as shown
above.
3.
Reinstall exhaust hangers if removed. Torque all fasteners to specifications below.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2007 Cequent Towing Products
Installation Instructions
Saturn Vue
Fascia
2
1
Tighten all 12mm fasteners with torque wrench to 92 lb.-ft., 125 N*M
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: SUV3 & SUV4
2
1
Qty. (4)
1/2" Conical washers
2
Sheet 1 of 3
75556N
Part Numbers:
75556
87445
44580
Max Gross
Max Tongue
Trailer WT
4000lb. (1816 Kg)
400 lb. (182 Kg)
4000 lb. (1816 Kg)
400 lb. (182 Kg)
6-26-07
Form: F205 Rev A 5-6-05
WT
Rev. A
Publicidad
Manuales relacionados para Cequent Towing Products 75556
Resumen de contenidos para Cequent Towing Products 75556
- Página 1 This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 75556N 6-26-07 Rev. A 2007 Cequent Towing Products Form: F205 Rev A 5-6-05...
- Página 2 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684. Hoja 2 de 3 75556N 6-26-07 Rev. A 2007 Cequent Towing Products Form: F205 Rev A 5-6-05...
- Página 3 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 3 de 3 75556N 6-26-07 Rev. A 2007 Cequent Towing Products Form: F205 Rev A 5-6-05...