EAS ELECTRIC ECH R32 Serie Manual De Instalación Y Usuario página 91

1) Use straight head screwdriver to insert into
the buckling position in the bottom of wire
controller, and spin the screwdriver to take
down the back cover. (Pay attention to
spinning direction, otherwise will damage
the back cover!)
2) Use three GB950-86 M4X20 screws to
directly install the back cover on the wall.
3) Use two M4X25 GB823-88screws to install
the back cover on the 86 electrician box,
and use one GB950-86 M4X20 screws for
fixing on the wall.
4) Adjust the length of two plastic screw bars in
the accessory to be standard length from
the electrical box screw bar to the wall.
Make sure when install the screw bar to the
wall, make it as flat as the wall.
5) Use cross head screws to fix the wire
controller bottom cover in the wall
through the screw bar. Make sure the
wire controller bottom cover is on the
same level after installation, and then
install the wire controller back to the bottom
cover.
6) Over fasten the screw will lead to deforma
tion of back cover.
4.3.4 Wire outlet
Cutting place of left
down side wire outlet
Left down
side wire
outlet
35
A
V.1