Audi 8T0 054 630 A Manual De Montaje página 23

Assembly Instructions
Original parking distance control system, Audi A5 2008 ®,
Audi A5 Sportback 2010 ®, Audi A4 saloon 2008 ®,
Audi A4 Avant 2009 ® and Audi A4 allroad quattro 2010 ®
Set contents:
1 x controller
N
1 x buzzer
N
4 x sensor
N
4 x covering rings
N
1 x mounting material
N
Accessories (not included in the set contents, please order separately if required):
1 x 8K0 907 297 Control units mounting bracket (only for cars without a factory-fitted mounting bracket)
N
Special tools, test and measuring equipment, and ancillaries required:
Flat-bladed screwdriver
N
Phillips screwdriver
N
Side cutters
N
Hand drill
N
Set of twist drills
N
Forstner bit ∅ 20 mm
N
Expanding / crimp grip pliers
N
Measuring and cutting tool
N
1 Procedure:
Note
The original parking distance control system should be fitted by a competent workshop. Incorrect fitting may lead
N
to damage to the car or the parking distance control system.
The work to be carried out on the car according to these fitting instructions is subject to change due to model
N
updates. For example, changes to the wiring colours or even the fitting locations are possible. Accordingly, ensure
that you always use the appropriate current circuit diagram or the current car workshop manual.
All rights to make technical changes reserved.
N
1.1 Paint sensors
Note
The sensor only require painting in the car colour when the bumpers are painted. In the bumpers are not painted,
N
the sensors do not require painting.
Do not use a silicon remover to clean the sensors prior to painting, rather use a mild alcohol, e.g. methylated spirits.
N
Leave the sensors in the packaging supplied to simplify painting; this is provided as a painting aid device.
N
Additional general painting information:
N
Self-study programme No. 214/215
Ÿ
Page 2 - figure 1
The figure gives an example of the protective rings -1- already placed in the correct position on the sensors -4-.
Place the covering rings -2- on the rubber membranes of the sensors -3-.
−
Paint the sensors -3- and -4- evenly, and not too thickly, in the same colour as the car.
−
Remove covering rings -1- and -2- carefully straight after painting (while the paint is still wet) using tweezers and
−
let the paint dry.
Note
The protective rings -1- and -2- must be placed on the sensors -3- and -4- before any painting is carried out.
Repaint as necessary after drying (e.g. clear lacquer for twin coat painting).
−
1 x power harness
N
1 x sensor harness
N
1 x Installation instructions
N
1 x operation manual
N
Pencil
N
Marking awl
N
Triangular file
N
Round file
N
Tweezers
N
Scissors
N
-VAS 1978- harness repair set
N
8T0 054 630 A
23