Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LOW BATTERY INDICATION
Low battery indication is available for the home receiver and the remote
sensor. Replace the batteries and follow the setup procedure as mentioned
in this instruction manual.
MAINTENANCE AND CARE INSTRUCTIONS
• Extreme temperatures, shock or areas of unusual vibration should be
avoided to prevent damage to the units.
• Clean the units using only a soft, damp cloth to wipe.
Do not use solvents, abrasives, detergents or other strong cleaning
agents. After cleaning, wipe surfaces with a dry cloth.
• Do not submerge units in water or other liquids.
• Do not subject the units to extremely severe temperatures - DO NOT
PLACE UNITS INTO OVENS, FREEZERS or MICROWAVE UNITS.
NOTE: Opening the housing of either the Remote Sensor or the Home
Unit will invalidate your warranty. Do not attempt to repair this unit –
There are no consumer serviceable parts.
6
MOUNTING INSTRUCTIONS
Both the Home Unit and Remote Sensor come with a table
stand or they can be wall mounted.
Table Top -
For the home unit, simply attach the stand provided.
For the remote sensor, simply fold out the attached stand
from the mounting bracket.
Wall Mounting -
For the Home Unit - Remove the table top stand from the
bottom of the unit. Fix a screw (not included) into the
desired wall and place the home unit onto the screw using
the back side hanging hole.
For the Remote Sensor - Fix two screws (not included) into
the desired hanging location using the mounting bracket
holes on the remote sensor as a template. Ensure that the
screws are placed vertically (in a straight line up/down) along
the surface and that there is proper distance between each
screw to hang the mounting bracket. Align the hanging holes
of the mounting bracket with the two screws and place unit
onto the screws.
NOTE: Keep the remote sensor out of direct sunlight and
rain. Do not mount on a metal surface.
7
Publicidad
Tabla de contenido
