2
To disconnect the tube parts from each other and from the handgrip of the hose, pull while
turning a little.
Note: Use the same method to connect and disconnect the nozzles.
telescopic tube
1
Adjust the tube to the length you find most comfortable during vacuum cleaning (Fig. 4).
Combination nozzle
The combination nozzle can be used on either carpets or hard floors.
1
To clean hard floors, push the rocker switch on top of the nozzle with your foot (Fig. 5).
The brush strip for cleaning hard floors comes out of the nozzle housing.
,
2
To clean carpets, push the rocker switch again. (Fig. 6)
The brush strip disappears into the nozzle housing.
,
Crevice tool and small nozzle
1
Connect the crevice tool (1) or small nozzle (2) directly to the handgrip or to the
tube (Fig. 7).
accessory clip
1
Snap the accessory clip onto the tube (Fig. 8).
2
Snap the crevice tool and the small nozzle onto the clip.
using the appliance
1
Pull the cord out of the appliance and put the mains plug in the wall socket.
2
Press the on/off button on top of the appliance with your foot to switch on the
appliance (Fig. 9).
3
During vacuum cleaning, you can adjust the suction power with:
-
the slide on the handgrip (specific types only) (Fig. 10)
-
the knob on top of the appliance (specific types only) (Fig. 11)
4
If you want to pause for a moment, insert the ridge on the nozzle into the parking slot to
park the tube in a convenient position (Fig. 12).
storage
1
Switch off the appliance and remove the mains plug from the wall socket.
2
Press the cord rewind button to rewind the mains cord (Fig. 13).
3
Put the appliance in upright position. To attach the nozzle to the appliance, insert the ridge
into the storage slot (Fig. 14).
4
Always put the Tri-Active nozzle in the carpet setting when you store it. Also prevent the side
brushes from becoming bent (Fig. 15).
replacing/emptying the dustbag
Always unplug the appliance before you replace the disposable dustbag or empty the reusable
dustbag.
English
7