Maintenance And Care - SPORTSTECH FX300 Manual Del Usuario

MAINTENANCE AND CARE

General maintenance and care will help to maintain the life and performance of your treadmill. Keep the unit
clean by dusting the components on a regular basis. Clean both sides of the running belt to prevent dust from
accumulating underneath the belt. Keep your running shoes clean to avoid the running board and belt getting
dirty. Clean the surface of the running belt with a clean damp cloth.
It is recommended that the machine is powered off for 10 minutes after 2 hours of continuous use and com-
pletely powered off whilst not in use.
A loose running belt can result to the runner sliding off while running. If the running belt is too tight it will decrea-
se the motors performance and also create more friction between the roller and running belts. The most suitable
position is when the belt is pulled out 50-75mm from the running board.
CENTERING THE RUNNING BELT:
Place the treadmill on level ground and set it at 6-8km/h to check if the Running Belt (No. C31) drifts.
If the running belt (No. C31) moves to the right, turn
the right adjustment bolt ¼ turn clockwise, then turn
the left adjustment bolt ¼ turn counter-clockwise. If
the belt does not move, repeat this step until it centers.
Refer to figure A.
EN
If the running belt (No. C31) moves to the left, turn the
left adjustment bolt ¼ turn clockwise, then turn the
right adjustment bolt ¼ turn counter-clockwise. If the
belt does not move, repeat this step until it centers.
Refer to figure B.
The running belt (No. C31) will loosen over time. To
tighten the belt turn the left & right adjustment bolts
one full turn clockwise, check the tension of the belt.
Continue this process until the belt has the right ten-
sion. Make sure to adjust both sides equally to ensure
correct belt alignment. Refer to figure C.
35