Furrion Vision S Manual De Instrucciones página 18

Installation
7. Place the attached cables and
connections into the bracket
housing by first placing the
cable to the right.
Place the camera cable filter in
the left of the bracket housing.
(Fig. 7)
Fig. 7
8. Fix the gasket and bracket to
the vehicle using four 3/4 " flat
self-tapping screws. Make sure
the camera power cable is not
damaged while attaching the
device to the vehicle. (Fig. 8)
17
Fig. 8
9. Make sure the sealing lip
around the edge of the gasket
is seated over the edge of the
bracket before fully tightening
the screws.
Connecting the Camera
WARNING
When connecting wires, ensure the
circuit is isolated by disconnecting
the negative terminal on the battery.
● Ensure correct polarity when
wiring the cables. RED + BLACK
-.
● Ensure correct polarity when
wiring.
● Wire connections and terminals
must be sealed and waterproof.