Care And Maintenance - KNOVA KN AP-07B Manual Del Usuario

5. HOW TO USE THE POLISHER
Before setting up. Repair or
maintenance of the appliance you
must always turn off the operating
switch and pull out the mains plug!.
6
5
7
Starting the unit
Ensure that the data listed on the
nameplate concurs with the mains
voltage before connecting the unit up.
On/Off switch
Power on by pushing the switch button (1)
to the left side.
Power off by opposite action.

6. CARE AND MAINTENANCE

Remove the plug form the socket
before carrying out any
adjustment, servicing or
maintenance.
Your power tool requires no additional
lubrication or maintenance. Always store
your power tool in a dry place.
If the supply cord is damaged, it must be
replaced by an Authorized Service Center
or qualified personal in order to avoid a
hazard. If a fault cannot be rectified, return
the equipment to an authorized dealer for
repair.
Cleaning
- Keep the safety devices, ventilation
slots and motor housing as free of dirt
Before initial operation
- Check if the rated frequency of the
mains supply corresponds to the details
of the type place.
- Before using the tool, read the
instruction book carefully.
4- Speed down
1- Switch
5- Spindle
2- Led
3- Speed up
Variable Speed
Press button (3) to increase the speed and
button (4) to decrease the speed.
Please note: The Nos. show on led (2) will
be 0, 10, 15, 20, 25, 30 and 35 which rep-
resent the speed is 0, 1,000, 1,500, 2,000,
2,500, 3,000 and 3,500 r/min Respectively.
Assemble and disassemble the Polishing
pad
Press the spindle lock (5) by one finger
meanwhile turn the pad for assemble and
disassemble purpose by the other hand.
and dust as possible. Clean the unit by
rubbing it with a clean cloth or blow it
clean using low-pressure compressed air.
- We recommend that you always clean
the unit immediately after using it.
- Clean the unit regularly by rubbing it
with a damp cloth and a little soft soap.
Do not use cleaners or solvents; these
will attack the plastic parts in the unit.
You must also ensure that water cannot
get into the inside of the unit.
Carbon brushes
- If excessive sparking occurs you must
have the carbon brushes checked by a
qualified electrician.
Attention! Only a qualified electrician
is allowed to change the brushes.
2
3
4
1
6- D-type
lock
7- Polishing
handle
pad