Publicidad
MAINTENANCE
BRASSWARE AND ACCESSORIES
First of all we thank you for buying our products which are manufactured to the highest standards. However
in common with other products our brassware requires the correct cleaning and periodic maintenance.
BRASSWARE SURFACES
As stated in the norm DIN EN 248 the materials used to plate brassware are Chrome, Nickel, stainless steel,
brass and others to leave a superior, easy to clean, pleasing finish. Before cleaning please check the material
used and only use a suitable cleaner.
CLEANING
To clean brassware and accessories please note the following recommendations.
- For regular cleaning only use warm soapy water, if this is not possible use soft non abrasive gels or similar
cleaning products, rinse thoroughly and polish with a soft cloth.
- Please avoid the use of harsh or abrasive products such as scouring powders, those products with phosphoric
acid, hydrochloric acid, formic acid or acetic acid that could badly damage the product. Please only use PH
neutral products.
- Keep sensor clean, away from any chemical impregnant.
- Dry the items after each cleaning sesion and after every use to avoid limestone appearance.
WARNING
- Cleaning materials will only worsen already damage product.
- Do not mix cleaning products, the chemical reactions can emit toxic fumes and react badly with product
surfaces.
- Do not use harsh or abrasive cloths, pads or cleaning products.
- Do not use bleach or other chlorine based cleaning products.
- Only use suitable cleaning products as recommended for each product he cleaning products only make
worse the surfaces if those are already damages.
- Do not operate sensor faucet in strong infrared environment.
RECOMENDATIONS FOR THE CLEANING AND PRESERVATION OF BRASSWARE AND
ACCESSORIES
- Read the manufacturers instructions.
- To protect the brassware, internal mechanism and to extend the life of the product it is recommended in line
with "best practice" to install isolation valves and in line filters.
- Regular cleaning to reduce lime scale and soap residue build up.
- Do not leave these products in contact with the product surface longer than the manufacturer's recommen
dations and rinse thoroughly with clean water.
- Do not spray cleaning products directly onto the product surface, spray onto a soft cloth and then apply to the
product. Spraying directly onto the product can lead to cleaning fluids being drawn into the products through
capillary action causing irreversible damage.
- If a tap is left dripping it may lead to staining and lime scale build up. Please ensure taps are correctly turned
off after use.
- Failure to comply with the maintenance instructions may invalidate the guarantee.
GUARANTEE CLAUSE
Not following the maintenance instructions can have as a consequence the cancellation of the valid guaran-
tee.
13
Publicidad
