Removing/Inserting The Battery; Recharging The Battery; Used Batteries; Operating - FLORABEST FHSA 20 B1 Traducción Del Manual De Instrucciones Original

• If a fully recharged battery lasts for con-
siderably shorter operating times, the
battery is used up and needs to be re-
placed. Only use an OEM spare battery
available from our Customer Service.
• Always take heed of the applicable safety
instructions as well as the environmental
protection regulations and information.
• The warranty excludes all defects
caused by improper handling.
Removing/inserting the
battery
1. To remove the battery from
the device, press the release
button (11) on the battery (9)
and pull the battery out.
2. To insert the battery (9), place it
on the guide track (15) and push
it back into the appliance. It will
audibly snap in.
Do not insert the battery until
the appliance is fully assem-
bled. Risk of injury!

Recharging the battery

Only charge the battery (
when the red LED on the charge
level indicator (
Charging time is approx. 1 hour.
1. Remove the battery (9) from the
appliance, as necessary.
2. Insert the battery (9) in the charg-
ing compartment of the battery
charger (12).
3. Plug the battery charger (12) into
a mains outlet. The red LED on the
control display (13), which is on
9)
10a) is on.
the charger, (12) comes on when
the battery (9) is loading. If the
green LED on the charger (12) is
on, the battery (9) is charged.
4. When the battery is fully re-
charged unplug the battery
charger (12) from the mains.
5. Pull the battery out of the battery
charger (12).

Used batteries

• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see "Waste Disposal and
Environmental Protection").

Operating

Wear suitable clothing and
work gloves when working
with the equipment.
Wear eye and ear protection.
Ensure that the equipment
is functional before each
use. The On/Off switch and
the safety switch must not
be held closed. They must
switch off the motor when on
is released. Should a switch
be damaged, stop working
with the equipment. Ensure
that the mains voltage value
matches the label on the
equipment.
GB IE
31