Mounting Configurations; Kit Contents - Schaefer WMTA24-B Instrucciones De Instalación

DESCRIPTION
Schaefer's wall mounts offer the flexibility to
mount circulation fans up to 42" on a wide
variety of surfaces using four distinct mounting
configurations. Mounts allow for 180° swivel
adjustment from side to side with the capability
to tilt up to 45° to direct the air where desired.
Assembled in the USA of heavy-duty steel, these
mounts will provide years of dependable fan
support for your cooling and air circulation needs.

MOUNTING CONFIGURATIONS

Schaefer's wall mount bracket can be assembled in four
configurations. Some configurations will limit the fan
angle adjustment range. The Long Leg Out, Short Leg Up
configuration allows the maximum listed fan to swivel and
tilt with no interference of the support structure or diagonal
brace.
Note: The swivel tab must always be mounted downward as
shown.
WALL BRACKET ASSEMBLY

Kit Contents:

Formed Bracket, Diagonal Brace, Swivel Tab
(2) 1/4"-20 x 3/4" Bolts, (2) 1/4"-20 Nylock Nuts, (4) 1/4" Washers
(1) 3/8"-16 x 1-1/4" Bolt, (1) 3/8"-16 Nylock Nut, (1) 3/8" Washer
Tools required:
(2) 7/16" Wrenches
(1) 9/16" Wrench
1. Orient the Formed Bracket and Diagonal
Brace so both hole patterns are aligned.
2. Join the Bracket and Brace with the 1/4"
hardware through the desired Swivel Tab end.
Use the 7/16" wrenches and tighten fasteners
securely.
3. Install Swivel Tab using the 3/8" hardware.
Insert the 3/8" Nylock Nut into the Swivel
Tab Slot feature. Hold the nut in position
while installing the 3/8" bolt.
9/16" Wrench to tighten the bolt until the
Swivel Tab is seated against the bracket but
still allows rotational movement.
Specifications
Part Number
WMTA24-B
WMTA24-SS
WMTA30-B
WMTA30-SS
WMTA36-B
* A larger fan can be mounted with a smaller mount, but it will have
limited swivel range of motion. Maximum fan weight: 75 lbs.
Step 1:
Step 3:
Use the
2
Maximum Fan* Size
12" - 24"
12" - 24"
12" - 30" (36")*
12" - 30" (36")*
12" - 36" (42")*
Long leg out, short leg down
Short leg out, long leg down
Holes
align
Capture
nut within
Swivel Tab
Slot
Finish
Powder Coated Black
Stainless Steel
Powder Coated Black
Stainless Steel
Powder Coated Black
Long leg out, short leg up
Short leg out, long leg up
Step 2:
Surface
contact