Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Hints for best reception:-
-
The receiver has a built-in bar antenna. If AM reception is weak. Slight rotate or re-positioning of the
AM :
unit will usually improve the AM reception.
-
The receiver has a built-in FM Wire Antenna (25) hanging at the rear cabinet. This wire should be totally
FM :
unraveled and extended for best reception.
Listening to Phono
NOTED:
-
Remove the stylus protector.
-
Be sure that the tone arm is being detached from the tone arm rest before
operating and re-secured again after wards.
1.
Select to "Phono" function from Function Selector(5)
2.
Set the speed selector to the proper position depending on the record to be played.
3.
Place the record on the platter(use the Spindle Adaptor if required).
4.
Lift the tone arm from the rest and slowly move it to the record side. The platter will start
to rotate.
5.
Place the tone arm to the desired position of the record.
6.
Adjust the volume to the desired level.
7.
At the end of the record, the platter will automatically stop rotating. Lift the tone arm from
the record and return to the rest.
8.
To stop manually, lift the tone arm from the record and return it to the rest.
As some kind of record the auto-stop area was out of the unit setting, so it will stop before the last
REMARK :
track finish. In this case, select the Auto-Stop Switch (22) to "Off" position. Then it will run to the end of the record
but will not stop automatically.(Turn off the unit by power button or switch back the Auto-Stop Switch(22) to
"On" position to stop the platter rotate). Then put back the tone arm to the rest position.
Remark : Due to Aux and Phono were designed at the same position of this system. When Aux in jack(24)
plugged by 3.5mm plug. The channel will change to Aux automatically and turntable will stop to rotate. Please
ensure the Aux in jack (24) without plugged by anything before playing Phono.
Aux-in connection
Connect the unit to other device by connecting the Aux in jack (24) with a 3.5mm cable(not provided) and other
end connect to the external device such as Discman/MP3 player to perform the music playback or encoding
function etc.
1. Slide the Function knob(5) to Phono/Aux position.
2. Adjust the Power ON-OFF/ Volume Control Knob(16) to desired volume level.
3. Start to play your external device.
Playback of MP3 song via USB storage media or memory card
Connecting
The system is able to decode and playback all MP3 file which stored in the memory media with USB connecting
port or SD.MMC memory card.
Function knob (5) to USB or SD mode
1.
Turn the
2.
Plug-in the USB with the face up and make sure it going into
completely or insert the memory card in the direction of the arrow as
shown in the label on the upside of the memory card slot. Insert
straight without bending.
Connecting the USB upside down or backwards could damage the
audio system or the storage media (USB thumb drive/SD/MMC
Card). Check to be sure the direction is correct before connecting.
3.
The system will start reading and playback the file in the storage media
automatically after connecting and the Play LED indicator (13) will light
up .
Remark : USB port does not support connection with USB extension cable and is not designed for
communicate with computer directly
4
Publicidad
Tabla de contenido
