Remington REM-L180BNO-V Manual Del Usuario página 8

PREPARE DAMPER
The chimney damper must be fixed open such that it always
maintains the minimum permanent vent opening. To achieve
this, a.) install a screw or bolt in the edge of the damper to
prevent the damper from closing, b.) drill a hole or holes in
the damper blade, or c.) install the provided damper clamp on
the edge of the damper blade (see Figure 2).
NOTE: In the State of Massachusetts, the chimney damper
must be removed or welded in the fully open position.
HEARTH KIT ASSEMBLY
NOTE: The following instructions apply to dual flame
"U"-style burners. Ensure all pipe-threaded connections
are tight, and use thread compound to prevent leaks.
1. Determine from which side the gas line will be
entering into the fireplace.
• Gas line on the right side: This appliance is
manufactured with the gas inlet on the right side
of the burner pan. See INSTALLATION AND GAS
CONNECTION, page 9.
• Gas line on the left side: Continue with step 2.
2. Remove the cover plate on left side of the burner
pan by using a screwdriver (see Figure 3).
3. Unscrew the burner inlet fitting from the burner
manifold (see Figure 3).
4. Place the burner manifold in the pan with the
threaded opening facing the opening on the left
side.
5. Using thread sealant (resistant to the action of
natural gas) on the larger end of the fitting, screw
the burner inlet fitting through hole and into burner
manifold. Tighten using a wrench (see Figure 4).
6. Using the provided burner clamp, screw, and nut,
attach the clamp to the pan. This holds the burner
manifold in place (see Figure 4).
7. Using the screws removed in step 2, install the cover
plate over the opening on the right side of the
burner pan (see Figure 4).
8. Attach the pan clamp brackets to the back of the
burner pan as shown (see Figure 5).
9. Position the grate into the V-grooves in the pan
clamp brackets (see Figure 5).
©2017 Pinnacle Climate Technologies
Installation (cont.)
8
Fig. 2
Damper
Damper
"Opened Position"
Damper Clamp
Fig. 3
Fig. 4
Fig. 5
Pan clamp bracket
Screw
Vented Gas Log Appliance User's Manual
Pan clamp bracket