Tabla de contenido
Publicidad
CO LLEGAM EN TO ELETTRICO
I
Controllare che la tensione dell'impianto elettrico corrisponda a quella indicata sulla
targhetta caratteristiche posta sul lato sinistro in basso nella parte interna dello scom-
parto frigorifero.
Se la presa a muro è priva di contatto a terra, o se la spina non è adatta al vostro
impianto vi consigliamo di rivolgervi ad un elettricista specializzato.
Non impiegare adattatori o derivatori che potrebbero causare riscaldamenti e bru-
ciature.
Gli apparecchi previsti per il funzionamento a 115V - 60 H:
(sprovvisti di cavo di alimentazione e di spina) devono essere collegati ad una rete di
alimentazione elettrica dotata di un dispositivo che assicuri la disconnessione
onnipolare dell'apparecchio dalla rete stessa, con una distanza di apertura dei con-
ELECTRI CAL CO N N ECTIO N
G B
Check that the main voltage corresponds to that indicated on the rating plate in the
lower left side inside the refrigerator compartment.
If the wall socket does not have an earth terminal, or if the plug does not fit into the
socket, it is advisable to consult a qualified electrician. Do not use multiple plugs or
adapters as they could cause heating and burning.
W a rning: this a pplia nce must be ea rthed
If this appliance is fitted with a non rewirable plug for which your socket is unsuitable,
the plug should be cut off and an appropriate plug fitted. The removed plug must be
disposed of Insertion of the plug into a 13 Amp socket is likely to cause an electrical
hazard When a nonrewirable plug ora rewirable 13 Amp (BS1363) plug is used it
must be fitted with a 13 Amp AST A approved (BS1362) fuse. If any other type of plug
is used it must be protected by a 15 Amp fuse either in the plug or at the distribution
board
Importa nt: The w ires in the ma in lea ds a re coloured in a ccorda nce
w ith the follow ing code:
1 2
Green and Yellow
to Earth
Blue to
Neutral
13 amp
Fuse
Brown
to Live
Cord
Clamp
tatti di almeno 3 mm. (es.: interruttore magnetotermico bipolare, interruttore differen-
ziale bipolare, ecc. ).
GREEN AN D YELLOW - EARTH BLUE - N EUTRAL
BROW N - LIVE
As the colours of the wires in the main lead of your appliance may not correspond
with the coloured marking identifying the terminals in your plug, proceed as follows.
CONNECT GREEN & YEL L OW coloured wire to plug terminal marked letter "E" or
earth symbol
or coloured green or green & yellow.
CONNECT BL UE coloured wire to plug terminal marked letter "N" or coloured black.
CONNECT BROWN coloured wire to plug terminal marked letter "L " or coloured
red.
Those appliances designed to operate at 115 V - 60 Hz (not pro-
vided with a power supply cable and plug) must be connected to an
electricity mains supply provided with a device which ensures the
omnipolar disconnection of the appliance from this mains supply,
with a contact break of at least 3 mm (e.g.: bipolar thermal mag-
netic circuit-breaker, bipolar differential circuit-breaker, etc.).
13
Publicidad
Tabla de contenido
