Mounting On Stands; Mounting On Bench; Pre-Operation Inspection; Machine And Work Area Set-Up - RIDGID 1224 Manual De Instrucciones

1224 Threading Machine
Failure to mount the threading machine to a stable
stand or bench may result in tipping and serious
injury.
ReV/oFF/FoR switch should be oFF and machine
unplugged before assembly.
use proper lifting techniques. The RIdGId 1224
Threading Machine weighs 509 lbs. (231 kg).

Mounting on Stands

The Threading Machine can be mounted on various
RIDGID Threader Stands. Refer to RIDGID catalog for
stand information and to the respective Stand Instruction
Sheet for mounting instructions.

Mounting on Bench

The machine can be mounted on a level, stable bench. To
mount the unit on a bench, use four
provided at each corner of the machine base. Base hole
spacing is 19.88" × 15.5" (505 mm x 394 mm). Tighten
securely.

Pre-operation Inspection

WARNING
Before each use, inspect your threading machine
and correct any problems to reduce the risk of seri-
ous injury from electric shock, crushing and other
causes, and to help prevent threading machine dam-
age.
1. Make sure that the threading machine is unplugged
and the REV/OFF/FOR switch is in OFF position.
2. Clean any oil, grease or dirt from the threading
machine, including the handles and controls. This
aids inspection and helps prevent the machine or
control from slipping from your grip. Clean and main-
tain the machine per the maintenance instructions.
3. Inspect the threading machine for the following:
• Condition of the cords and plug for damage or
modification.
• Proper assembly, maintenance and completeness.
• Any broken, worn, missing, misaligned or binding
parts or other damage.
• Presence and operation of the foot switch. Confirm
that foot switch is attached, in good condition, that
it cycles smoothly and does not stick.
6
3 / " bolts in holes
8
• Presence and readability of warning labels (Figure
1).
• Condition of the dies, cutter wheel and reamer cut-
ting edges. Dull or damaged cutting tools increase
required force, produce poor results and increase
the risk of injury.
• Any other condition which may prevent safe and
normal operation.
If any problems are found, do not use the threading
machine until the problems have been repaired.
4. Inspect and maintain any other equipment being
used per its instructions to make sure it is functioning
properly.

Machine and Work Area Set-up

WARNING
Set up the Threading Machine and the work area
according to these procedures to reduce the risk of
injury from electric shock, machine tipping, entan-
glement, crushing and other causes, and to help pre-
vent threading machine damage.
Secure machine to stable stand or bench. Properly
support pipe. This will reduce the risk of falling
pipe, tipping and serious injury.
do not use the Threading Machine without a prop-
erly operating foot switch. A foot switch provides
better control by letting you shut off the machine
motor by removing your foot.
1. Check work area for:
• Adequate lighting.
• Flammable liquids, vapors or dust that may ignite.
If present, do not work in area until source is iden-
tified, removed or corrected, and area is completely
ventilated. The threading machine is not explosion
proof and can cause sparks.
• Clear, level, stable, dry location for all equipment
and operator.
• Good ventilation. Do not use extensively in small,
enclosed areas.
• Properly grounded electrical outlet of the correct
voltage. Check the machine serial plate for required
voltage. A three-prong or GFCI outlet may not be
properly grounded. If in doubt, have outlet inspect-
ed by a licensed electrician.
940-713-030.10_REV. G