Pump Lubrication - Smith S103E Manual De Uso Y Cuidado

Steps To Cleaning Your Sprayer
*** To prevent clogging issues, after each use clean your sprayer.***
1. Release pressure in your sprayer via pressure relief valve. Do not undo handle without releasing pressure.
2. Empty remaining chemical back into original filling container.
3. Fill sprayer with water, place pump back into tank, and tighten.
4. Aggressively shake the water in the tank to try and get residue off of the inside walls of the sprayer. Repeat
step if necessary, each time refilling with fresh water.
5. Pressurize the sprayer and spray water for 30-45 seconds into a disposable reservoir, then release pressure
and remove the pump from the tank.
6. Tip and empty tank, then set tank upright. Hold wand and shut-off above the tank and depress the
shut-off. The liquid will drain into the tank, empty again.
7. Repeat the steps above as necessary.
8. Allow tank to air dry by leaving the pump outside of tank over night. The next day, replace the pump to
keep debris out of the tank.
Sprayer Storage
1. Sprayer tank should be hung upside down, with the pump removed.
2. Do not store or leave any solution in the tank after use.
3. Store in a warm, dry location out of direct sunlight.
4. Keep the sprayer and all chemicals out of reach of children.

Pump Lubrication

Pump should be periodically oiled by applying 10 to
12 drops of light oil down the pump rod through the
opening in the pump cap as shown.
OPERATING INSTRUCTIONS CONTINUED
MAINTENANCE
Page 5