Electrical Connection; Panel Assembly - ELICA Rules BL 60 Montaje Y Modo De Empleo

Installation
The minimum distance between the supporting surface for the
cooking equipment on the hob and the lowest part of the
range hood must be not less than 50cm from electric cookers
and 65cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify a
greater distance, this must be adhered to.

Electrical connection

The mains power supply must correspond to the rating
indicated on the plate situated inside the hood. If provided with
a plug connect the hood to a socket in compliance with current
regulations and positioned in an accessible area, after
installation. If it not fitted with a plug (direct mains connection)
or if the plug is not located in an accessible area, after
installation, apply a double pole switch in accordance with
standards which assures the complete disconnection of the
mains under conditions relating to over-current category III, in
accordance with installation instructions.
WARNING!
Before re-connecting the hood circuit to the mains supply and
checking the efficient function, always check that the mains
cable is correctly assembled.
The hood is provided with a special power cable ; if the cable
is damaged, request a new one from Technical Service.
Mounting
Before beginning installation:
• Check that the product purchased is of a suitable size for
the chosen installation area.
• Remove the charcoal (*) filter/s if supplied (see also
relative paragraph). This/these is/are to be mounted only
if you want lo use the hood in the filtering version.
• Check (for transport reasons) that there is no other
supplied material inside the hood (e.g. packets with
screws (*), guarantees (*), etc.), eventually removing
them and keeping them.
Very heavy product; hood handling and installation must
be carried out by at least two persons.

Panel Assembly

(only for models where the panel is not supplied with the
hood)
CAUTION!
Installation must be carried out only by qualified installers.
FOR THE INSTALLER: Responsibility for installation of the
hood, including verification of the conformity of any fixing kit
supplied with the product, is the sole responsibility of the
installer. Following is a non-exhaustive list of helpful
instructions for the installer:
- use a fireproof PANEL (compliant with art. 30 of IEC/EN
60335-2- 31), suitable for the operating temperature (at
least 80°C) and humidity (at least 93%) reached during use;
total weight of PANEL used should not exceed 4KG;
secure the PANEL to the hood using the fixing points. See
the illustrations dedicated to assembly of the panel not
supplied with the hood.
use suitable mechanical parts to fix the PANEL (not
included in the assembly kit). Elica denies all liability for
damage to persons or property resulting from incorrect
installation of the gypsum panels and/or product.
28