Viewing Live Images On A Monitor (Basic Connections) - Sanyo VCC-N6584 Manual De Instrucciones

Viewing Live Images on a Monitor
All the power supplied to the system should be turned off when you connect devices.
Thicker than RG-6U (5C-2V): 500 m / 547 yds. max.
(Non-PoE power supply)
Power Supply Connection
To prevent a fire hazard use any UL listed
wire rated VW-1.
AC 24V
Check that +/– polarity is correct.
DC 12V
1 Thicker than 18 AWG
Alarm Signal Output
If a lamp is connected to this cable, it will
light up when an alarm signal is received
or when the built-in motion sensor detects
movement.
External
peripheral
equipment
• To use the ALARM OUT setting, you must
make the appropriate ALARM OUT
settings for CAMERA SETTINGS in the
network settings.
Monitor Connection
Using different cables from those specified here may
attenuate the video and/or sync signals and interfere with
correct transmission.
1
~
~
GND
1
+
–
(ALARM OUT)
(COM)
(Basic Connections)
POWER
GND
CLASS 2 WIRING
Thicker than 24 AWG, 600 m / 656 yds. max.
Alarm Signal Input
Alarm
input
signal
• To use the ALARM IN setting, you must
make the appropriate ALARM IN settings
for CAMERA SETTINGS in the network
settings.
6
ALARM OUT
VIDEO OUT
ALARM IN
COM
LAN
LINK
(ALARM IN)
(COM)