How To Assembly The Blades & Light Kit - Fanimation The Ventana FP8032DZ Manual De Instrucciones

How to Assemble the Blades and Light Kit
1. Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
arm. With a Phillips screwdriver, tighten 3/16˝-24
washer head screws and fiber washers to secure
the blade to the blade arm (Figure 1).
CAUTION
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
2. Secure the blade holders to the motor support
u s n i g h t e / 1 4˝ 2 - 0 c s
on the bottom of the motor support (Figure 2).
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
!
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades
or cleaning the fan. Do not insert foreign objects in
between the rotating blades.
CAUTION
To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing
light kit.
3. Remove one of the three screws in the support
bracket at the bottom of the motor assembly.
Slightly loosen the remaining two screws.
Assemble the light plate assembly to the
support bracket using the two key slots in the
socket plate. Replace the third screw and securely
tighten all three screws (Figure 3).
e r w s h t o r u g h h t e h o e l s located
WARNING
3/16˝-24 WASHER HEAD
SCREW AND FIBER
WASHER (3 each per blade)
HARDWARE USED:
3/16˝-24
WASHER HEAD
SCREWS
FIBER WASHER
1/4˝-20 SCREWS
(2 per assembly)
HARDWARE USED:
1/4˝-20
SCREWS
SCREWS (3)
11
BLADE
BLADE HOLDER
Figure 1
x 15
x 15
BLADE HOLDER
MOTOR
ASSEMB L Y
Figure 2
x 10
HOUSING LIGHT
SUPPORT
KIT ASSEMBLY
BRACKET
Figure 3