Tecnogas MagBlue Manual Del Usuario página 12

Flow diagram (IMGs. A - B - C)
Dirty water
Filtered water
"Right-angles" working position
(90° inlet and outlet - IMG. A)
1. inlet valve
Mount the
2. Close the other inlet through the supplied
3. Make sure that the inlet valve
valve is closed and it is installed as in the figure.
5
4. Install the dirt separator so that the dirty water inlet is in the
valve , and the filtered water outlet is through the
1
.
2
12
ring nut
on the first joint under the
1
stopper
is open and that the
1
TECNOGAS manuale di installazione | setup manual
ENGLISH
"Horizontal" work position
(Horizontal inlet and outlet - IMG. B)
1.
Mount the
ring nut
2. Plug the other inlet via the supplied
3. Be sure to install the supplied
This allows to create the
2
4.
Be sure that the
is closed and installed as in the figure.
. 5.
Install the dirt separator so that the not yet filtered water inlet
3
. is in the
4
drain outlet pipe
As in point 1, it is possible to install the inlet valve on
outlet pipe
both lateral inlet pipes. Installing the inlet valve on the
i
lower joint allows to install a bypass system due to the
remaining space between inlet and outlet pipes. This is
necessary, for example, while working with equipment
that requires high operational continuity.
inlet valve
on the first or second joint under the
1
.
3
stopper
90° bend
outlet in parallel
inlet valve is open and the
1
valve , and the filtered water outlet is through the
1
.
2
.
4
on the outlet pipe.
11
with the valve .
1
drain valve
5