Important Notes; Lace-Up Wrist Brace Without Thumb Piece; Fitting Instructions - Ofa Bamberg dynamics Manual Del Usuario

Important notes

Lace-up wrist brace
without thumb piece
Dear user,
We are pleased that you have chosen a
product from Ofa Bamberg and would like
to thank you for putting your trust in us.
Please take a moment to read through this
product information carefully to ensure
optimum effectiveness of your Dynamics
product.
Ofa Bamberg wishes you a speedy
recovery!
←

Fitting instructions

The fi tting instructions in pictures can be found on the fold-over
page at the beginning of the brochure.
1
To put on the orthosis, open the Velcro fastener of the lacing. Pull the
orthosis over the wrist in such a way that the hand and thumb opening
is pointing away from your body and the moulded aluminium splint is on
the inside of your wrist.
2
Now close the orthosis by guiding the lacing around your wrist and se-
curing it by Velcro fastening it on the top of the orthosis. Please ensure
that the product is secure but not too tight in order to prevent pinching.
3
Finally, adjust, if necessary, the Velcro fastener between your thumb
and your index finger.
The Dynamics lace-up wrist brace
provides optimum wrist immobilisation. An
anatomically contoured aluminium splint
positions the wrist in a relaxing neutral po-
sition. The practical lace-up system makes
the orthosis easy to put on and distributes
the pressure evenly.
Please note
– The initial adjustment and strap-
ping on of the product must be
carried out by qualifi ed specialist
staff. The aluminium splints can
be moulded when cold.
– Wear the product directly on
your skin. If it has to be worn
in combination with other
products, then please discuss
this in advance with your doctor.
– If you experience an unpleasant
sensation, intense pain or any
other problem when wearing
the product, then remove it and
contact your doctor or specialist
supplier.
– We use a comprehensive quality
management system to check
our products. However, should
there still be reasons for com-
plaint, please contact your spe-
cialist supplier.