Whittier Wood Products 784W Instrucciones Para Armar página 6

FIG. 6
6. Attach the Crown Moulding (GG) and Base (HH). See FIGURE 6.
FIG. 7
SQUARE THE UNIT:
7. With the unit laying face down on a protective surface, measure from top left to bottom right
( / ) and from bottom left to top right ( / ). Measurements should be equal. If the line ( / ) is
longer, tap bottom of Left Side Panel (BB) until measurements are equal. If line ( / ) is longer,
tap bottom of Right Side Panel (AA). See FIGURE 7.
Fasten the Back Panel (FF) to the unit through the pre-drilled holes in the back panel using the
#6 x 5/8" Philtruss Screw (LL). Be careful not to over-tighten the screws as you might strip the
wood.
PAGE 6 – 772W & 784W
x24
(772W)
LL
x26
(784W)