TO LEVEL THE UNIT:
10. Rotate adjustable glides in the corner braces until unit stands level.
TO ATTACH MORE THAN ONE UNIT TOGETHER:
11. Be sure the units are tight together. Screw one end of the Mending Plate (S) to the top of the
Crown Moulding (GG) of each unit using #8 x 5/8" Phillips Head Screw (W). BE CAREFUL TO
PLACE THE MENDING PLATE NEAR THE BACK EDGE OF THE CROWN MOULDING SO
THAT THE SCREWS DO NOT COME THROUGH THE FACE.
P x1
T x1
W x1
FIG. 12
12. Position wall unit at desired location. Locate stud in wall behind unit. Attach "L" Angle Bracket (T)
to wall stud with #8 x 1¼" Pan Head Screw (P) so that the other half of bracket may be attached
to Top Shelf (DD) of wall unit with #8 x 5/8" Pan Head Screw (W). See FIGURE 12. If stud in
wall cannot be located, purchase proper wall attachment hardware for your type of wall and
secure the unit.
If units are attached together, each unit should have the angle bracket attached to the wall.
PAGE 8 – 772W & 784W