Installing And Removing Flat Panel Display; Top View - peerless-AV PT630 Instalación Y Ensamblaje

Installing and Removing Flat Panel Display

Position top slots of hook plate (B) onto phillips hex head screws on wall plate (A) as shown in fi gure 3.1.
3
NOTE: Sides of hook plate (B) must be outside of wall plate (A) on both sides as shown in fi gure 3.2.
Guide slots of hook plate onto four phillips hex head screws as shown in fi gure 3.3.
Push or pull from top or bottom of display to adjust tilt as shown in fi gure 3.4. The tilt can be adjusted to a maximum
of 15° forward or 5° backward. To lock the display into the desired tilt position, tighten phillips hex head screws on
both sides of mount.
To remove display from mount, loosen screws one full turn and lift display off of mount.
• Do not lift more weight than you can handle. Use additional man power or mechanical lifting equipment to safely
handle placement of the display.
CAUTION
• Do not tighten screws with excessive force.
Overtightening can cause damage to mount. Tighten
screws to 40 in. • lb (4.5 N.M.) maximum torque.
fi g. 3.1
DISPLAY
fi g. 3.2
DISPLAY

TOP VIEW

SLOT
PHILLIPS HEX
HEAD SCREW
B
A
SIDES OF HOOK PLATE
(B) ON OUTSIDE OF
WALL PLATE (A)
WALL
WARNING
• Be careful not to pinch fi ngers when pushing display
from the bottom.
fi g. 3.3
fi g. 3.4
7 of 23
All other brand and product names are trademarks or registered trademarks of their respective owners.
CAUTION
B
A
PHILLIPS HEX
HEAD SCREWS
ISSUED: 11-19-07 SHEET #: 202-9245-5 09-01-11
© 2011, Peerless Industries, Inc. All rights reserved.
PHILLIPS HEX
HEAD SCREWS
Peerless Industries, Inc.
2300 White Oak Circle
Aurora, Il 60502
www.peerlessmounts.com