NSK FX15 Manual Del Usuario página 10

5) Use the bur to gently lever the entire cartridge out from the head.
(Fig.8)
6) Clean the head interior with NSK PANA SPRAY Plus.
7) Wipe the NSK PANA SPRAY Plus oil over the head interior.
8) Insert the new cartridge into the head by aligning the pin on the
cartridge with the slot on the head. (Fig.9)
9) Tighten the head cap with the correct wrench.
10) Insert the drive shaft firmly into the handpiece head until it clicks. If
the click is not heard, insert it again.
11) Reattach the shank.
*Refer to Spare Parts List to identify the correct cartridge.
CAUTION
• After removing, do not hold the shank upside down as it could
cause the internal parts to drop.
• Before turning the head cap, make sure the wrench is correctly
aligned with the cap. Do not turn the wrench at an angle as
abrasion of the wrench may occur.
• Secure the shank firmly to the handpiece head so that there is
no gap between them. A loose connection could make the head
unstable, resulting in an accident during use.
• Use only a genuine NSK cartridge.
• If a non genuine cartridge is used NSK cannot guarantee
performance and the handpiece warranty would become invalid.
• Always first finger tighten the head cap then secure firmly with the
wrench.
• NSK never recommends the disassembly and repair of any NSK
cartridge. There is NO EXCEPTION. In such a case a handpiece
may perform abnormally (abnormal noise or abnormal vibration).
Damage, failure or accidents are outside of our guarantee.
7