Marking And Identification; Mounting Of The Hose - Piusi HC Instalación Uso Y Mantenimiento

6 - MARKING AND IDENTIFICATION

We affix the CE marking as the manufacturer of this equipment.
On the equipment is securely attached
a tag with curing adhesive system on
which are indicated in addition to the
name of the manufacturer and the
symbol "CE", all information necessa-
ry for good identification of the machi-
ne (model, duty, year of construction,
weight, etc.)
7 - MOUNTING OF THE HOSE (Models without hose)
The hose reels without hose are supplied with the unloaded
spring.
Use a hose with dimension and pressure characteristics suitable
for use, as described on the schedules, according to the hose reel
code.
7.1) Fix the hose reel to the bench. Take out the access door by
levering with a screwdriver.
7.1
7.2) Put the hose between the guide rollers, connect it to the
fitting which is inside the drum and tighten by the suitable
wrench.
7.3) Put the hose rubber stop at about 50 cm from the opposite
end of the hose.
7.4) Loosen the two screws on the spring side by a 10 mm
wrench.
7.5) Insert an hex wrench of 14 mm into the hole of the shaft.
7.2
Rotate the wrench anti-clockwise (+) and wind the hose un-
til when the hose rubber stop is in contact with the rollers
support.
7.6) Pre-load the spring while continuing to turn anti-clockwise
(+) the wrench, respecting the turns preload reported in the
technical data table. Hold in position and block the shaft by
the two screws.
7.7) Unwind the hose and rewind it completely, to check if the
hose reel works properly.
7.3
If the hose does not rewind or does not withdraw complete-
ly, adjust the spring tension.
When complete, place the hose rubber stop at the desired
distance from the end of the hose.
DO NOT PUT YOUR HANDS INSIDE THE
HOSE REEL!
7.4
7.8) Mount again the side access door.
7.5
- 11 -
PIUSI S.p.a.
46029 Suzzara (MN) ITALY
MADE IN ITALY
WEIGHT:
LOT NUMBER:
2015
R E A D I N S T R U C T I O N
7.6 7.7