Descargar Imprimir esta página

Brandson Equipment 303846 Manual De Usuario página 28

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

5. Installation
Take the appliance out of the package and remove all the packaging material. Then
check the product for any damage. Choose a suitable socket and connect the fan
heater to it. The place of installation of the heater should be at least 1 meter away
from other objects and the ground.
Caution! Make sure that the appliance is not placed near flammable materials or
any liquids. The air outlet should also not point in this direction.
Note: To ensure that the heater works and heats properly, the desired temper-
ature must be set on the heater so that it is a couple of degrees higher than the
room temperature. If the heater does not start heating, increase the desired
temperature on the heater to activate the heating elements.
6. Initial use
Connect the appliance to a 220-240 V AC socket. Set the ON/OFF switch at the side
of the appliance to position "I" to start the fan heater. The heater then shows the
current temperature in the display. To switch off the appliance, set the "ON/OFF"
switch to "0".
Press the "
" button on the control panel at the front of the fan. The ventilation
starts now.
You can adjust the desired room temperature using the temperature buttons "+" (
) and "-"(
). The fan heater now heats until the specified room temperature
is reached.
Note: The fan heater is connected to a timer. Wait for 60 seconds after switching
the appliance off before disconnecting it from the socket.
Thermostat function
Press the temperature button "+" (
) and "-" (
) to set the desired temperature.
Temperatures between 15°C and 45°C can be set. If the set temperature is less than
or equal to the current air temperature, the heating function is switched off. The
fan does not switch off and maintains the set temperature.
28
English

Publicidad

loading