Product Safety; Important Safety Instructions - Worx WG601 Manual De Instrucciones

PRODUCT SAFETY

WARNING: Read all safety warnings and
all instructions. Failure to follow the
warnings and instructions may result in
electric shock, fire and/or serious injury.
Save all warnings and instructions for future
reference.
WARNING: This product can expose you
to chemicals including lead and
Di(2-ethylhexyl)phthalate (DEHP) which
are known to the State of California to cause
cancer and birth defects or other reproductive
harm. For more information go to www.
P65Warnings.ca.gov.

IMPORTANT SAFETY INSTRUCTIONS

WARNING: When using this product basic
precautions should always be followed,
including the following:
1. Read all the instructions before using the
product.
2. To reduce the risk of injury, close supervision is
necessary when a product is used near children.
3. Know how to stop the product and bleed
pressures quickly. Be thoroughly familiar with
the controls.
4. Stay alert – watch what you are doing.
5. Do not operate the product when fatigued or
under the influence of alcohol or drugs.
6. Keep operating area clear of all persons
2
7. Do not overreach or stand on unstable support.
Keep good footing and balance at all times.
8. Follow the maintenance instructions specified in
the manual.
9. This Product Is Provided With A Ground Fault
Circuit Interrupter Built Into The Power Cord
Plug. If Replacement Of The Plug Or Cord Is
Needed, Use Only Identical Replacement Parts.
10. Do not spray electrical apparatus and wiring.
11. WARNING – To reduce the risk of
electrocution, keep all connections dry
and off the ground. Do not touch plug with wet
hands.
12. WARNING – Risk of injection or
injury– do not direct discharge stream at
persons.
SAVE THESE INSTRUCTIONS
CORD CONNECTED, DOUBLE INSULATED
PRODUCTS
1.GROUND FAULT CIRCUIT INTERRUPTER
PROTECTION
This pressure washer is provided with a ground-fault
circuit-interrupter (GFCI) built into the plug of the
power-supply cord. This device provides additional
protection from the risk of electric shock. Should
replacement of the plug or cord become necessary,
use only identical replacement parts that include GFCI
protection.
13A Electric Pressure Washer
2. SERVICING OF A DOUBLE-INSULATED
APPLIANCE
In a double-insulated product, two systems of
insulation are provided instead of grounding. No
grounding means is provided on a double-insulated
product, nor should a means for grounding be added
to the product. Servicing a double-insulated product
requires extreme care and knowledge of the system,
and should be done only by
qualified service personnel. Replacement parts for a
double-insulated product must be identical to the parts
they replace.
3. EXTENSION CORDS
Use only extension cords that are intended for outdoor
use. These extension cords are identified by a marking
"Acceptable for use with outdoor appliances; store
indoors while not in use. " Use only extension cords
having an electrical rating not less than the rating of
the product. Do not use damaged extension cords.
Examine extension cord before using and replace if
damaged. Do not abuse extension cord and do not
yank on any cord to disconnect. Keep cord away from
heat and sharp edges. Always disconnect the extension
cord from the receptacle before disconnecting the
product from the extension cord.
SAFETY RULES FOR EXTENSION CORD
Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one
heavy enough to carry the current your product will
draw. An undersized extension cord will cause a
drop in line voltage resulting in loss of power and
overheating. Table 1 shows the correct size to use
depending on cord length and nameplate ampere
rating. If in doubt, use the next heavier gage. The
smaller the gage number, the heavier the cord. To
reduce the risk of disconnection of appliance cord from
the extension cord during operating:
I) Make a knot as shown in Figure 1; or
II) Use one of the plug-receptacle retaining straps or
connectors described in this manual.
Table 1 Minimum gauge for extension cords
Volts
120V 25
Ampere rating
more than not
more than
14
12-16
FIGURE 1
METHOD OF SECURING EXTENSION CORD
APPLIANCE CORD
CORD
SET
Total length of cord in feet
50 100 150
AWG
Not
12
recommended
EN