Setting Menu - Sony JJTRON ADN-8118 Manual De Instrucciones

SETTING Menu

The SETTING menu is used for changing the default
settings of the unit.
Select the setting item with the V or v key, then
change the setting with the B or b key.
S E T T I N G
I N P U T : I N P U T – A
S T A T U S : O N
A U T O P O W E R : O N
K E Y L O C K : O N
S E L E C T C A N C E L
ENTER
INPUT
Selects the input signal.
INPUT-A: Selects the RGB signal input from the
equipment connected to the INPUT A connectors.
RGB: Selects the RGB signal input from the
equipment connected to the INPUT B connectors
when the optional JJTRON Accessory Board is
installed.
YUV: Selects the component signal input from the
equipment connected to the INPUT B connectors
when the optional JJTRON Accessory Board is
installed.
VIDEO: Selects the video signal input from the
equipment connected to the INPUT B connectors
when the optional JJTRON Accessory Board is
installed.
Type of input signal
INPUT-A: 31.5 kHz/60 Hz, 31.25 kHz/50 Hz
RGB: 15 kHz/60 Hz, 15 kHz/50 Hz
YUV: component 50 Hz, component 60 Hz
VIDEO: NTSC, PAL, SECAM, MONO (50 Hz),
MONO (60 Hz)
STATUS
Selects the on-screen display mode.
ON: Shows all of the on-screen displays.
OFF: Turns off all of the on-screen displays except for
menu displays.
MENU
AUTO POWER
Selects how to turn on the power of the unit.
ON: Turns on when the breaker at the rear of the unit
is raised.
OFF: Enters standby mode when the breaker is raised,
then turns on by pressing the ON key on the
Remote Commander or the POWER ON button on
the unit.
KEY LOCK
Locks the buttons on the control panel to prevent
accidental operations.
ON: Locks the buttons on the control panel.
OFF: Resumes normal operation.
Note
When KEY LOCK is set to ON, you can unlock the
buttons on the control panel by pressing and holding
the WIDESCREEN MODE and STANDBY buttons
on the control panel simultaneously for two seconds.
The unit enters standby mode.
When the unit is in standby mode, it turns on and the
buttons are operable by pressing and holding the
WIDESCREEN MODE and POWER ON buttons on
the control panel simultaneously for two seconds.
25
(GB)