HAMPTON BAY 51012 Guía De Uso Y Cuidado página 10

Assembly - Hanging the Fan (continued)
7
Wrapping the extra wire
NOTE: Follow this step ONLY if you did not cut the extra
length from the wires coming from the ceiling fan.
□
Gently wrap the excess wire around the mounting
bracket.
□
Secure the wires with electrical tape.
8
Mounting the fan
WARNING: The locking slots of ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattached
until all four canopy screws are engaged and firmly tightened.
WARNING: When using the standard ball/downrod mounting, the
tab in the ring at the bottom of the mounting bracket must rest in
the groove of the hanger ball. Failure to properly seat the tab in
the groove could cause damage to the wiring.
□
Align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the slots,
and turn clockwise to lock the canopy (C) in place.
□
Firmly tighten the two mounting screws (II).
□
Install the two mounting screws (JJ) (save from Assembly Step
1 "Preparing for mounting" ) into the holes in the canopy (C) and
tighten firmly.
□
Install the decorative canopy ring (K) by aligning the ring's slots
with the screws in the canopy (C). Rotate the ring counter-
clockwise to lock it in place.
A
□
□
□
II
K
D
10
Close-to-Ceiling mounting
WARNING: The locking slots of the ceiling canopy are provided only
as an aid to mounting. Do not leave the fan assembly unattended
until all four canopy screws are engaged and firmly tightened.
Carefully unhook the fan from the mounting bracket (A) and
align the locking slots of the ceiling canopy (C) with the two
screws in the mounting bracket (A). Push up to engage the
slots and turn clockwise to lock the canopy (C) in place.
Immediately tighten the two mounting screws (II) firmly.
Install the two mounting screws (JJ) (save from Assembly
Step 1 "Preparing for mounting" ) into the holes in the canopy
(C) and tighten firmly.
Install the decorative canopy ring (K) by aligning the ring's
slots with the screws in the canopy (C). Rotate the ring
counterclockwise to lock it in place.
A
II
D