Chef's Choice 2100 Manual De Instrucciones página 2

EdgeCraft offers the 15° Ceramic knife sharpening module designed specifically to place a
factory quality edge on all ceramic knives. It can be used interchangeably on the Model 2100
Sharpener with the standard 20° module designed for the European/American style metal
blades and all other 20° metal knives and the and the 15 degree module for sharpening 15
degree metal blades of contemporary Euro/American and Asian/ Japanese style metal knives.
The Ceramic sharpener module is identical in size to the other modules and it can be removed
or installed on the guide rails of the Model 2100 as described in the Model 2100 manual.
INSERTING SHARPENING MODULE
To reinsert the Sharpening Module into the main motor housing, insert the shaft coupling end of
the Sharpening Module into the guide rails at the right end of the sharpener. Then gently push
the Sharpening Module toward the motor housing until it locks in place. If it resists snapping
into the locked position: (1) Pull the module away from the motor shaft until it fully disengages;
(2) Turn the motor switch ON briefly; (3) Then turn it OFF; (4) While the motor is still coasting to a
stop, push the Sharpening Module into place. It will then automatically snap into position when
the spline coupling becomes properly self-aligned.
SHARPENING FIRST TIME WITH CERAMIC KNIFE MODULE
With this Ceramic knife module inserted on the Model 2100 and before you turn on the power
you might want to become familiar with this sharpener. Slip a ceramic knife smoothly into the
slot between the left angle guide of Stage 1 and the knife guide spring (see Figure 1). Do not
twist the knife. Move the blade down in the slot until you feel it contact the diamond disk. Pull it
toward you, lifting the blade handle slightly as you approach the tip. This will give you a feel for
the spring tension that guides the knife.
INSTRUCTIONS FOR USE OF
CERAMIC SHARPENING MODULE
Figure 1. Sharpening a ceramic knife, first in both slots
of Stage 1.
2