Stiga T8743 Manual Del Propietário página 3

HARDWARE NEEDED
1/4-20 X 3 1/4 Hex Head Bolt
29
(Qty. 4)
¼" Flat
31 34
Washer
(Qty. 8)
1. Attach Caster Wheels (#9 & #10) to Caster Beam Assembly. Slide a Caster
Wheel with Lock (#10) through Caster Beam Assembly (#7) and secure it
with a Push Nut (#11) as shown in Figure 1. Gently tap the Push Nut
(#11) with a hammer to secure it in place. On the other end of the Caster
Beam attach a Caster Wheel without Lock (#9). Make sure you have one
caster wheel with lock and a caster wheel without lock for each Caster
Beam Assembly.
Repeat this step to attach the Casters to the second Caster Beam Assembly.
2. Attach Wood Bottom Board (#15) to Caster
Beam Assemblies (#7) as shown in Figure 1.
Turn Caster Beams as shown and attach board
with four Hex Head Bolts (#29), eight Flat
Washers (#31) and four Locknuts (#34).
Tighten nuts securely.
NOTE: Make sure logos are
right side up and facing
the outside as shown.
11
3/8" Push Nut
¼" Locknut
(Qty. 4)
(Qty. 4)
11
Caster
with
10
Lock
ASSEMBLY TIP
Note: Support Plate (#43)
must be on inside of Caster
Beam (#7) as shown.
29
Caster
without
9
Lock
7
31
31
31
31
34
3
On the top of each page you will find a picture of the
Hardware Needed (to scale) along with the Quantity,
Key# and Description. You can lay the hardware on
the picture to identify and sort the hardware.
CAUTION:
READ AND FOLLOW ALL ASSEMBLY, OPERATING, AND
SAFETY INSTRUCTIONS CAREFULLY. AT LEAST TWO (2)
ADULTS ARE NEEDED TO PUT THIS TABLE TOGETHER!
43
31
31
15
34
Caster
9
without
Lock
29
31
7
Caster
with
Lock
10
31
Figure
1