Stiga T8743 Manual Del Propietário página 7

32
1/4-20 X 3 1/2 Hex Head Bolt
9. Secure U-support tube (#21) to Strut Tubes (#17) with two Screws (#5) as
shown in Figure 5. Align holes in U-support with holes in Strut Tubes and
thread screw (#5) into hole in Strut Tube (#17). Tighten screws all the way
but be careful not to over tighten as you could strip threads on screws.
10. Attach Linkages (#16) to Leg (#19) as shown in Figure 5. Pivot Leg
(#19) out from the table top and pivot both linkages (#16) up and
align hole in Linkage with hole in Leg (#19). Attach Linkage (#16) to
Leg (#19) using Hex Head Bolt (#32), Spacer (#37) and Locknut
(#34). Spacer (#37) goes between Linkage and Leg. Attach other
Linkage to Leg the same way. Tighten nuts securely.
32
16
16
HARDWARE NEEDED
(Qty. 2)
Figure
34
37
5
Note: Make sure
to install #5
screws
17
34
1/4-20 Locknut
(Qty. 2)
5
34
21
17
7
37
1/2" Long Spacer
(Qty. 2)
#8 X 9/16
5
Screw
(Qty. 2)
19
32
37
Spacer goes between
Linkage Arm (#16)
and Leg (#19)
16
5