Publicidad
Idiomas disponibles
Idiomas disponibles
Putting into service and Operation (mobile):
-
Place the dust cover onto the tub with grease
Follower cover.
-
Remove the lid from the grease tub.
-
Push the grease follower piston onto the grease in
the tub, until it is visible in the central hole. The
rubber lip must be in uniform contact with the wall
of the tub.
-
Place the dust cover on the tub with the grease
follower cover and tighten all 3 wing bolts
uniformly.
-
Push the pump gear support down to the dust
cover and secure with the wing nut.
-
Push the pump unit through the pump gear
support, the dust cover and the grease follower
cover, to the base of the grease container. Secure
the pump unit with the wing nut.
-
Connect the high-pressure armoured rubber hose
with lubrication gun to the pump unit.
N.B. Check that the centralising lid is seated firmly
on the grease container.
-
The pump can now be pushed through the clamp
and locked in place with the clamping screw.
-
Push the ZSA hydraulic coupling onto the plug of
the central lubrication unit..
-
The pneuMATO fill is now ready to use.
-
If the unit is not in use, stop the air feed to the
pump.
Comply with the safety instructions .
8
Armoured
Shut-off tap
rubber hose
Grease outlet
ZSA Hydraulic
coupling
Accessory
Dust cover
Grease
follower piston
Publicidad
