Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly
Section
3
ASSEMBLY
Your generator requires some assembly and is ready for
use after it has been properly serviced with the
recommended oil and fuel.
If you have any problems with the assembly of your
generator, please call the generator helpline at
1-888-611-6708. If calling for assistance, please have the
model, revision, and serial number from the data tag available.
See "Know Your Generator" for data tag location.
Remove Generator From Carton
1.
Set carton on a rigid flat surface with "This Side Up"
arrows pointing upward.
2.
Carefully open top flaps of shipping carton.
3.
Cut down corners of carton from top to bottom and
lay that side of carton down flat.
4.
Remove all packing material, carton fillers, etc.
5.
Roll generator out of shipping carton.
Attach Handle
You will need two 1/2" or 13 mm wrenches to attach the
handle.
1.
Attach handle to right side of generator frame (viewing
unit from front), as shown in Figure 1, with a 60 mm
capscrew, flat washers, nylon washers, and lock nut.
Figure 1 — Attach Handle
Lock Nut
Flat Washers
NOTE: DO NOT overtighten. Handle must be able to
move up and down freely.
2.
Raise handle and insert handle pin to move generator.
6
Handle Pin
60mm Capscrew
Nut
Washer
Handle Bracket
Nylon Washer
Nylon Washer
Handle Bracket
Washer
60mm Capscrew
Handle Pin
Publicidad
Capítulos
Tabla de contenido
