Important Assembling Advice - ESS Easy Drain Vinyl Consejo Para La Instalación

Important assembling advice: Vinyl
Suitable for renovation work and new construction
The shower drain should only be installed by specialist companies in compliance with the building
regulations. To achieve the best possible result, please carefully read the installation guide. If you have any
questions, please consult your supplier.
Please check the content of the package for
▪
completeness and integrity before proceeding with
the assembly. Do not install the channel drain if any
deviations are noted. Should this be the case, please
consult your supplier.
Prior to the assembly, the assembling advice and its
▪
special characteristics should be discussed with the floor
layer. After the assembly, please provide the tiler with the
complete assembling advice.
If the shower drain is used for several showers, please
▪
check to make sure that the drainage capacity is
sufficient. If you are unsure, please consult the supplier
for advice.
We recommend taping the drain opening of the shower
▪
drain prior to the assembly to prevent construction
debris from getting into the drainage pipe. To prevent
damage to the frame, it should be kept in the package
until the final installation by the tiler.
Assemble the height adjustable supports and level the
▪
shower drain all around. Mount the earthing on one of
the anchoring clips.
▪ Install the sewage system in compliance with the
standards. Note: ensure that the sewage system is well
ventilated and that the gradient is sufficient.
Check the shower drainage system and the sewer
▪
system connections for tightness.
The drain must be fully lined and sealed with floor
▪
pavement to the upper edge of the flange to prevent
hollow spaces.
The seal is applied in compliance with general standards
▪
for indoor sealing of wet areas. If alternative seals
are used, please read the manufacturer's product
information.
When floors are being fitted, the gradient of the floor
▪
(min. 2% per linear metre) in the shower must always
be towards the drain. The floor should be laid level or
1 mm higher than the top edge of the frame to ensure
good drainage toward the shower drain. Note: the
requirements with regard to the floor gradient may be
different for walk-in showers with glass walls. Please
consult your supplier in this respect.
The adhesion surfaces should be free of mortar, adhesive
▪
Typing and printing errors reserved. Easy Sanitary Solutions BV excludes all liability for any damages whatsoever associated with the use and/or
the installation of the drain. Easy Sanitary Solutions BV a priori excludes any liability whatsoever.
14 Vinyl
and other adhesion-reducing materials.
The shower drain system is only intended for use with
▪
waste water common in households. Do not use other
fluids as well as cleaning agents with the potential to
damage sanitary equipment, drainage equipment and
raw materials.
If the shower drain is used for other purposes (e.g.
▪
swimming pools), where it may come in contact with
aggressive cleaning agents or corrosive substances such
as salt or chlorine, please consult your supplier.
Compliance with this installation advice is required for
▪
any warranty claims based on our sale and delivery
terms.
Caution !
Cleaning products often contain aggressive chemicals
▪
that are abrasive in nature and may damage the drain.
Please ensure that the drain is thoroughly flushed after
using any tile and grout cleaning products.
UK