General Instructions - T&S B-0107 Manual Del Usuario

General Instructions

To replace worn parts:
1. Shut off water supply and drain
lines. For ease of disassembly and
reassembly, the handle grip can be
removed from no.3.
2. Unscrew no.5 and no.6 to remove
no.4. Unscrew and remove no.16 from
no.3.
3. Hold no.20 with pliers in one hand,
and with screwdriver, carefully unscrew
no.13 from no.16
4
20 16
5
6
4. Apply no.21 over full length of
no.13 and all over no.18. Replace no.14
(brassy side toward no.16), no.15,
no.17, no.18 & no.19 with new parts.
Apply no.21 again over full length of
no.13 and all over no.18.
20 19 18 16
17 15
5. Reassemble no.16 by inserting
no.13 through all parts. Hold no.20
with pliers, and carefully screw no.13
into no.20 until screw feels tight. Do
not use excessive force. (See step 4).
6. Reinsert no.16 in no.3 and tighten
securely.
7. To replace no.9, unscrew no.11 and
disassemble. Make sure the groove
side of no.9 fits into no.8, and no.10
rests on ridge side, as shown.
8. To replace no.2, unscrew handle
3
grip from no.3 and replace with new
no.2.
9. Reassemble; turn on water and
14 13
check for leaks.
Caution: Turn off water supply at
4
11
3
2
Handle
Grip
base faucet when not in use.
10
9
8
1